Parameters - Solver Parameters:
This menu allows the user to enter solver parameters that fall into four
categories.
Iteration Controls, Tolerance Controls, Display Controls and Convergence
Controls.
| Iteration controls are used to specify maximum number of
passes the solver will perform in different parts of the solution
process. Max. Flow must be equal or less than Max. Overall. By adjusting
the Max. Flow iterations you can solve flow to a point and then use it
in thermal analysis. |
 |
| The tolerance controls are used to specify the level of
accuracy deemed acceptable by user in solving specific equations. The
flow tolerance must be equal or greater than overall. Raising the flow
tolerance can make the flow solution converge faster at the expense of
a little bit of accuracy which can decrease the time to solve the
thermal field without harming your results. |
User Manual